removing a programmed zone in a ge networx nx 148e

SELECTING THE MODULE TO PROGRAM Tip: All modules connected to the NX control panel are programmed through the keypad. You are now in the Program Mode and ready to select the module.Ģ. If the 'Go To Program Code' is valid, the LCD screen will prompt for the device address to program. DISPLAYS IN THE PARTITIONING MASTER MODE. SET ELAPSED TIME IN MINUTES SINCE LAST AUTOTEST. ADJUSTING THE VIEW & BRIGHTNESS OF THE LCD. Indicates a key or button should be pressed to enter data.ĮNTERING THE PROGRAM MODE. Provides helpful information that is not normally defined in regular use, but from an experienced user. Indicates an essential or important procedure, instruction, condition, or statement. ** This symbol indicates general warnings and cautions. Indicates a procedure, practice, condition, or statement that, if not strictly observed, could result in damage to or destruction of equipment or property. * This symbol indicates electrical warnings and cautions. Indicates a procedure, practice, condition, or statement that, if not strictly observed, could result in personal injury. Technical Support 88 Sales & Literature 80 Web: SAFETY SYMBOL LEGEND Please refer to the current GE Security product catalog for detailed warranty information. This document shall not be reproduced in whole or in part nor shall its contents be disclosed to any third party without the written approval of GE Security. This document contains proprietary information of GE Security, USA and is furnished to its customer solely to assist that customer in the installation, testing, operations, and/or maintenance of the equipment described. If further information is desired or if particular problems arise that are not covered sufficiently for the purchaser’s purpose, the matter should be referred to GE Security, USA. These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to be met during installation, operation, and maintenance. NetworX™ Series NX-148E LCD Keypad Installation and Setup

Removing a programmed zone in a ge networx nx 148e